Tail Cutters

Water Jet Tailcutter

Made entirely of stainless steel, this cutter is available with customer water supply or new water supply systems. Cut positions are accurately set, and fully adjustable. Double or single nozzles are available,
with edge trim squirts available.

FEATURE LIST

• Operating pressure up to 5000 psig (340Bar)
• Water connections at drive side or tending side for existing customer water supply or new water supply system
• Very compact rigid structural beam design – unlimited cross machine length
• All internal beam components in stainless steel
• Unique, “V” wheel carriage to maintain positive motion without play/backlash
• DC cross drive motor with rugged reduction gearbox – fully sealed
• PLC automatic control system or fully manual operation.
• Double or single nozzle
• Adjustable Edge trim squirts with either remote or local adjustment available

Rotary Saw Blade Tailcutter

Simple, reliable and versatile, with single, dual, or portable hand held control stations. These feature a very compact, rigid structural beam design for unlmited cross-machine length, and fully-adjustable or preset positions to optimize precise tail cut positioning. Special tooth designs on the rotary saw blade minimizes dust and controls fiber build-up and plugging.

FEATURE LIST

• Air motor driven saw blade
• Hardened steel blade with non-plugging, low dust, tooth design
• Sheet stabilizing plate integral to cutting head
• Compact rigid structural beam in stainless steel or epoxy coated structural steel
• All internal beam components in stainless steel
• Pivot mechanism to engage cutting head into sheet
• Unique, “V” wheel carriage to maintain positive motion without play/backlash
• AC or DC cross drive motor with rugged reduction gearbox
• PLC automatic control system or fully manual operation.
• Standard design is suitable for wet or dry end of the machine

Knife Blade Tailcutter

Simple, reliable and versatile, with single, dual, or portable hand held control stations, these feature a very compact, rigid structural beam design for unlimited cross-machine length, and fully-adjustable or preset positions to optimize precise tail cut positioning. No tools are required to quickly change the blade on this simple, low maintenance cutter. The head can be parked at front or drive side for blade changes, and a sheet stabilizing plate is integral to the cutting head.

FEATURE LIST

• All stainless steel design
• Designed to accept typical “Utility Knife” blade or special hardened steel blade for extended blade life
• Toggle clamp design for blade exchange
• Beam and control designs – same as Rotary Saw Blade unit